16 bit parallel to serial converter ic
- #16 bit parallel to serial converter ic how to
- #16 bit parallel to serial converter ic 1080p
- #16 bit parallel to serial converter ic serial
You should remove additional 6 bits per pixel and display the actual frame size in the host application.įigure 2. Therefore, the frame size increases to 1.6 times of actual frame size. This increases the pixel size to 1.6 times of actual pixel size. Out of 16 bits, only 10 bits are actual data and rest 6 bits are additional bits padded for every clock. In this example, GPIF II is configured in 16-bit data bus mode therefore, it samples 16 bits per clock. However, fixed GPIF II supports configuring 8/16/24-bit data bus.
#16 bit parallel to serial converter ic serial
This means that MIPI CSI-2 is converting the input serial RAW10 data into parallel 10-bit data. The data format under MIPI CSI-2 inputs is RAW10 and data format under CX3 MIPI interface configuration is RAW10.
#16 bit parallel to serial converter ic 1080p
#16 bit parallel to serial converter ic how to
Note: See AN90369 - How to Interface a MIPI CSI-2 Image Sensor With EZ-USB® CX3 for information additional to the contents of this article.ġ. Exposure to absolute maximum conditions for extended periods may affect device reliability.Translation - Japanese: RAW10形式の入力データをCX24 MIPI CSI-2の16/24ビット出力形式にストリーミングする - KBA224387 - Community Translated (JA)
![16 bit parallel to serial converter ic 16 bit parallel to serial converter ic](https://i.stack.imgur.com/eRbbt.png)
NOTE: (1) Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. –0.3V to +VCC + 0.3Vĭigital Inputs to GND. The ADS8341 is available in an SSOP-16 package and is ensured over the –40☌ to +85☌ temperature range. The serial interface also provides low-cost isolation for remote data acquisition. Low power, high speed, and an onboard multiplexer make the ADS8341 ideal for battery-operated systems such as personal digital assistants, portable multi-channel data loggers, and measurement equipment. The ADS8341 is tested down to 2.7V operation. The device includes a shutdown mode that reduces power dissipation to under 15µW. The reference voltage (VREF) can be varied between 500mV and VCC, providing a corresponding input voltage range of 0V to VREF. Typical power dissipation is 8mW at a 100kHz throughput rate and a +5V supply. The ADS8341 is a 4-channel, 16-bit sampling Analog-toDigital (A/D) converter with a synchronous serial interface.
![16 bit parallel to serial converter ic 16 bit parallel to serial converter ic](https://i.ebayimg.com/images/g/wwYAAOSwEWZdMHWk/s-l400.jpg)
16-Bit, 4-Channel Serial Output Sampling ANALOG-TO-DIGITAL CONVERTER